Third Year Engineering Project – Wearable ECG Monitor Sticky

This project aims to design a low power battery operated wearable device with wireless capability that can measure ECG from the bipotential single channel. The system is lightweight and small since it will be worn for a long period without a battery recharge. Use professional tools & software during development. Understand low level embedded systems and overcome problems which are specific to the project using OEM datasheet/documentation.

Year In Industry – Review Sticky

Company: Buckman Hardy Associate Position: Junior Embedded EngineerStart Date: June 2018End Date: September 2019 Summary: The year in industry is part of the 4-year BENG course from the university of kent. It contributes 10% to the final grade. The aim of this is to get real-world industry experience. Much has been achieved over the course of 15 

Continue Reading…

Controlling Electronic Devices Using The Internet – NodeJS || Arduino Communication Project Sticky

Introduction This project in a nutshell: Controlling an Arduino micro controller from a web interface. Therefore control any electrical device from anywhere with internet. I wanted to stretch my understanding on programming and web development and what better way to do this then doing a simple but effective project. The hardware is kept at a 

Continue Reading…

VHDL Mini Project – Xilinx Spartan FPGA

Part of the final year digital systems design module included a mini VHDL project. The aim of this project is to extend the knowledge learned in second year and incorporate it all into a single project.  Project specification: In this mini-project, you are required to design, verify and implement of a digital phase shifter and frequency 

Continue Reading…

Aquaculture Engineering – Tilapia Research

Tilapia Breeding: The biology of many individual tilapia species is now well known and the interest in using these species for fish farming has led to considerable developments in recent decades. The principal practical reasons for farming tilapia are: simple reproduction/breeding processes; rapid growth rate; good tolerance to high stocking densities and intensive rearing conditions; 

Continue Reading…

Autonomous RC Car Engineering Society Project – Using Computer Vision

Previous Next Project Overview Design a working rc car which incorporates a computer e.g raspberry pi / mobile phone that can stream the data to a separate computer (for image analysis ) alternatively the processing can be done on the pi once it has learned. Using OpenCV neural network and haar-cascade classifiers train the car 

Continue Reading…

RGB Bluetooth Light Control with App

Video shows earlier development of the project where it only had an single LED. The project was later improved to work with 5050 RGB programable neo pixel strip with minor changes. This project took only few days and I was extremely inexperienced back in 2017.  https://www.mahmed.tech/wp-content/uploads/2017/04/BLE-Light.mp4 Bluetooth controlled RGB light using the arduino Bluetooth module 

Continue Reading…